|
| |
Intercomp CW-250 Portable floor scale
- Ideal for drums, chlorine
cylinders, hazardous medical waste and other containers
- Capacities ranging from
300 to 2,000 lb/150 to 1,000kg
- All aluminum self
contained unit provides accuracy of +/-0.1%
- Available in 15 x 15 or
24 x 24 inch/metric equivalent
- Can interface with an
optional printer or remote display
- Accumulation and printout
of multiple weights
NTEP
#95-024 |
With its compact
design, plus easy portability, the Intercomp Model CW250 Scale is ideal for weighing 55-gallon drums, chlorine cylinders,
propane bottles, freon tanks, hazardous medical wastes and other
liquid or gaseous containers. But those are just a few uses. Think
of the many other items in your plant that you can weigh with it.
It's available in twelve high performance models with capacities
ranging from 300 to 2,000 lb/150 to 1,000kg. There are two sizes of
weigh platforms:
15" x 15"x4"/380x3803100 mm, and
24"x24"x4"/610x610x100mm. This rugged, all aluminum,
self-contained unit provides accuracy of +/-0.1% (NTEP Class III) of
applied load.
Fully battery operated, this Intercomp scale requires only
infrequent recharging from any 12, 120 or 220 volt power source
(charger adaptor and cable provided). For night use, you light up
the display area by just touching the "lamp" switch. To
record weights, the scale will interface with an optional printer or
display (such as our P-DP printer or SA2000 display). |
Options
- 220V, 50Hz Charging Transformer
- 20mA Current Loop/RS232 Output
- Ramp
- Battery Operated Tape Printer
- Transport Wheels
|
|
|
general information
This unit is designed as an NTEP Class III weighing device.
Data Interface: 20mA current loop/RS232 Output
Batteries: Six AA 1.2 volt nickel cadmium (standard), or
six AA 1.5 volt alkaline
Battery Life: Approximately five years (1500
charge/discharge cycles.)
Battery duration between charges:
Approximately 8 hours of continuous use before the low battery
indicator comes on, and up to two hours after that before the
scale automatically shuts itself off. (These numbers are lowered
by use of lamp or active current loop transmission.)
Charging Voltage: 11.5 volts to 14.5 volts DC. Protection
is provided for accidental reversal of charging connections.
Charging Current: Starts at 300mA and drops down to 50mA
after 8 hours.
Charging Time: 8 hours if the batteries are discharged to
the point of shutting off the scale.
Construction: All aluminum design provides EM/RFI immunity.
Accuracy: +/-0.1% of applied load (NTEP Class III)
|
Controls:
General: All located on waterproof membrane keypad
with large contact surfaces.
Print: Outputs weight local
On/Off: Two separate switches for unambiguous
operation.
Zero/Test: Pushbutton zero checks for motion to
HB-44. Test performs internal test.
Hold/Release: Hold places scale in automatic capture
mode for in-motion weighing. Release places scale in
"normal" static weighing mode.
Lamp: Momentary action to activate high efficiency
light emitting diodes for night usage.
lb/kg: Sets unit of measure
Local/Total: Local is the standard mode for
weighing. Total enables the scale to accumulate weights with other
similar scales. Indicators:
Total: Accumulative mode of weighing
Battery: Low battery
Hold: In-motion weighing mode
lb/kg: Unit of measure
Performance:
Speed: 950 milliseconds to typical reading (static).
Accuracy: +/-0.1% of reading static mode.
+/-0.2% of reading holding mode.
Units: lb, kg selectable
Safe Overload: 150% of capacity
|
Specifications
Ambient
Humidity: 5 to 95% Non-Condensing
Temperature:
Operating:
-28 C to 65 C
-20 F to 150 F
Storage:
-40 C to 75 C
-40 C to 170 F
EMI/RFI: Meets Mil Spec 461
|
Physical:
Dimensions and weight:
24x24x4"/610x610x100mm
85 lbs./39 kg
15x15x4"/380x380x100mm
38 lbs./17kg
Case: Aluminum
Electrical:
Voltage; Self-contained nickel cadmium batteries (standard) or alkaline.
Integral recharger to charge or operate from a 12, 110 or 220 volt
power source. |
Capacities and graduation sizes available:
|
Model |
Capacity / Graduation |
Platform size |
weight |
Price |
Buy |
|
CW250-300-1S |
300X.1 lb/150X.05kg |
15"x15"x4" |
38
lb |
1,001.25 |
Use drop down arrow
to select part number
|
|
CW250-500-2S |
500X.2 lb/230X.1kg |
15"x15"x4" |
38
lb |
1,001.25 |
|
CW250-1000-5S |
1000X.5 lb/450X.2kg |
15"x15"x4" |
38
lb |
1,001.25 |
|
CW250-1500-5S |
1500X.5 lb/680X.2kg |
15"x15"x4" |
38
lb |
1,001.25 |
|
CW250-2000-5S |
2000X.1 lb/900X.5kg |
15"x15"x4" |
38
lb |
1,001.25 |
|
CW250-300-1 |
300X.1 lb/150X.05kg |
24"x24"x4" |
95
lb |
1,121.25 |
|
CW250-500-2 |
500X.2 lb/230X.1kg |
24"x24"x4" |
95
lb |
1,121.25 |
|
CW250-1000-5 |
1000X.5 lb/450X.2kg |
24"x24"x4" |
95
lb |
1,121.25 |
|
CW250-1500-5 |
1500X.5 lb/680X.2kg |
24"x24"x4" |
95
lb |
1,121.25 |
|
CW250-2000-5 |
2000X1 lb/900X.5kg |
24"x24"x4" |
95
lb |
1,121.25 |
|
Options |
|
100480 charger & cable (1) scale |
2 lb |
120.00 |
|
CW-R24 cast aluminum ramp 24"x24" |
21 lb |
246.75 |
|
CW-R15 cast aluminum ramp 15"x15" |
20 lb |
171.75 |
|
P-DP battery operated tape printer
(prints weight only) |
8 lb |
596.25 |
|
CW-TW transport Wheel (2 per platform) |
12 lb |
71.25 |
|
330010 battery pack w/6 AA NiCad
batteries |
1 lb |
38.50 |
|
|
www.Loadcells4u.com
